[AIServo86]
説明
Stops multiple servos at the same time. After calling this function, the behavior of each servo is the same as the behavior of stop().
構文
aiservoMultiStop()
aiservoMultiStop(servo1)
aiservoMultiStop(servo1, servo2)
aiservoMultiStop(servo1, servo2, ... , servo64)
媒介変数
servo1 ~ servo64: Variables of AIServo type.
You can enter 1 to 64 parameters of AIServo type, specify the servo to be started, or enter no parameter; when no parameter is entered, it means to stop all servos.
戻り値
なし
例
#include <AIServo86.h>
AIServoPort(ROBOTIS, AX12) bus;
AIServo servo0;
AI Servo servo1;
void setup()
{
bus.begin(Serial2, 1000000);
servo0. attach(bus, 6);
servo1. attach(bus, 10);
servo0.setPosition(150);
servo1.setPosition(160);
aiservoMultiRun(servo0, servo1); // start servo0, servo1 servos
delay(500);
}
void loop()
{
servo0.setPosition(90, 2000);
servo1.setPosition(200, 2000);
aiservoMultiRun(servo0, servo1); // make servo0, servo1 rotate to the new target position
delay(1000);
aiservoMultiStop(servo0, servo1); // stop all servos
delay(3000); // stop for 3 seconds
servo0.setPosition(150, 1800);
servo1.setPosition(160, 1200);
aiservoMultiRun(servo0, servo1); // make servo0, servo1 rotate to the new target position
while(isAIServoMultiMoving() == true); // wait for all servos to go to target position
}参照
ライブラリリファレンスホーム
86Duinoリファレンスのテキストは、Arduinoリファレンスを改変したもので、Creative Commons Attribution-ShareAlike 3.0ライセンスに基づいてライセンスされています。リファレンス内のコードサンプルはパブリックドメインとして公開されています。