我想找...

搜尋

分享

目錄

digitalWrite()

[Digital I/O]

描述

Write a HIGH or a LOW value to a digital pin.

If the pin has been configured as an OUTPUT with pinMode(), its voltage will be set to the corresponding value: 3.3V for HIGH, 0V (ground) for LOW.

語法

digitalWrite(pin, value)

參數

pin:腳位。
valueHIGH 或 LOW

回傳

範例程式碼

int ledPin = 13;                // LED connected to digital pin 13
 
void setup()
{
  pinMode(ledPin, OUTPUT);      // sets the digital pin as output
}
 
void loop()
{
  digitalWrite(ledPin, HIGH);   // sets the LED on
  delay(1000);                  // waits for a second
  digitalWrite(ledPin, LOW);    // sets the LED off
  delay(1000);                  // waits for a second
}

Sets pin 13 to HIGH, makes a one-second-long delay, and sets the pin back to LOW.

注意

Unlike Arduino, the analog input pins (referred to as A0, A1, etc) of 86Duino cannot be used as digital pins.

參考


語法參考主頁面

86Duino 參考的文本是根據 Creative Commons Attribution-ShareAlike 3.0 License,部分文本是從 the Arduino reference 修改的。 參考中的代碼示例已發佈到公共領域。

發表評論

上部へスクロール