Keyboard.write()

[USB]

描述

Sends a keystroke to a connected computer. This is similar to pressing and releasing a key on your keyboard. You can send some ASCII characters or the additional keyboard modifiers and special keys.

Only ASCII characters that are on the keyboard are supported. For example, ASCII 8 (backspace) would work, but ASCII 25 (Substitution) would not. When sending capital letters, Keyboard.write() sends a shift command plus the desired character, just as if typing on a keyboard. If sending a numeric type, it sends it as an ASCII character (ex. Keyboard.write(97) will send 'a').

For a complete list of ASCII characters, see ASCIITable.com.

WARNING: When you use the Keyboard.write() command, the 86Duino takes over your keyboard! Make sure you have control before you use the command. A pushbutton to toggle the keyboard control state is effective.

語法

Keyboard.write(character)

參數

character : a char or int to be sent to the computer. Can be sent in any notation that’s acceptable for a char; for example, all of the below are acceptable and send the same value, 65 or ASCII A:

Keyboard.write(65);         // sends ASCII value 65, or A 
Keyboard.write('A');        // same thing as a quoted character
Keyboard.write(0x41);       // same thing in hexadecimal
Keyboard.write(0b01000001); // same thing in binary (weird choice, but it works)

回傳

int : number of bytes sent

範例

void setup() {
  // make pin 2 an input and turn on the 
  // pullup resistor so it goes high unless
  // connected to ground:
  pinMode(2, INPUT_PULLUP);
  Keyboard.begin();
}
 
void loop() {
  //if the button is pressed
  if(digitalRead(2)==LOW){
    //Send an ASCII 'A', 
    Keyboard.write(65);
  }
}

參考

• Keyboard.begin()
• Keyboard.end()
• Keyboard.press()
• Keyboard.print()
• Keyboard.println()
• Keyboard.release()
• Keyboard.releaseAll()

語法參考主頁面

86Duino 參考的文本是根據 Creative Commons Attribution-ShareAlike 3.0 License，部分文本是從 the Arduino reference 修改的。 參考中的代碼示例已發佈到公共領域。