motor.enableTouchProbe2()

[EtherCAT Device CiA402]

説明

Enable the touch probe 2.

Relevant Objects

• Object 60B8_h: Touch probe function
• Object 60B9_h: Touch probe status
• Object 60D0_h: Touch probe source

構文

int enableTouchProbe2(int trigger_mode, int trigger_src, int trigger_timing);

媒介変数

• [in] trigger_mode
  Choose the trigger mode of touch probe 2:

定義	コード	説明
CIA402_TPMODE_FIRST_EVENT	0	Trigger the first event.
CIA402_TPMODE_CONTINUOUS	1	Trigger events continuously.

• [in] trigger_src
  Choose the trigger source of touch probe 2:

定義	コード	説明
CIA402_TPSRC_TP_INPUT	0x00010000	Trigger with touch probe input.
CIA402_TPSRC_ENCODER_Z	0x00020000	Trigger with zero impulse signal or position encoder.
CIA402_TPSRC_DIGITAL_INPUT1	1	Trigger with digital input 1.
CIA402_TPSRC_DIGITAL_INPUT2	2	Trigger with digital input 2.
CIA402_TPSRC_DIGITAL_INPUT3	3	Trigger with digital input 3.
CIA402_TPSRC_DIGITAL_INPUT4	4	Trigger with digital input 4.
CIA402_TPSRC_HW_ENCODER_Z	5	Trigger with digital input 5.
CIA402_TPSRC_SW_ENCODER_Z	6	Trigger with digital input 6.

• [in] trigger_timing
  Choose the trigger timing of touch probe 2:

定義	コード	説明
CIA402_TPTIMING_NONE	0	Switch off all sampling of touch probe 2.
CIA402_TPTIMING_POS_EDGE	1	Enable sampling at positive edge of touch probe 2.
CIA402_TPTIMING_NEG_EDGE	2	Enable sampling at negative edge of touch probe 2
CIA402_TPTIMING_BOTH	3	Enable sampling at both positive and negative edges of touch probe 2 simultaneously.

戻り値

error codeを返します。返された値が 0の場合、この関数が正常に完了したことを示します。

備考

この関数は、 　. This function is blocking and cannot be called in callback functions.

例

#include "Ethercat.h"

EthercatMaster master;
EthercatDevice_CiA402 motor;

void setup() {
  Serial.begin(115200);
  while (!Serial);

  master.begin();
  motor.attach(0, master);

  motor.enableTouchProbe2(CIA402_TPMODE_FIRST_EVENT, CIA402_TPSRC_TP_INPUT, CIA402_TPTIMING_POS_EDGE);
  while (motor.isTouchProbe2ValueReady(CIA402_TPVALUE_POS_EDGE) == false);
  Serial.print("Touch probe position 2 positive value: ");
  Serial.println(motor.readTouchProbe2Value(CIA402_TPVALUE_POS_EDGE));
  motor.disableTouchProbe2();
}

void loop() {
  // put your main code here, to run repeatedly:

}

---

詳細は EtherCAT CiA 402 ユーザーマニュアル QEC EtherCAT命令とAPI使用法参照